Note: It is ReadyLift's position that
our objective is to provide a product that levels the vehicle. Through
on-going research we have discovered that Toyota trucks have a unique
pattern of being manufactured and sold with varying degrees of rear to
front rake. It appears that many Toyota trucks are not the same height
or possess the same rake as the same stock truck sitting next to it. Our
research has determined there can be as much as 1.0" difference in rake
and ride height from truck to truck. TRD-equipped trucks often have
only 1.0" of rake compared to a non-TRD truck. Measurements on some
customer's trucks have revealed as much as 1.0" difference in the
factory front end height.
If you measure the truck at stock height, then install a 3" strut
extension and determine after installation and alignment that the truck
sits nose high, you most likely are an owner of one of the trucks that
has less rear to front rake. To compensate for the difference, ReadyLift
suggests installing one of our 1.0" (2044021) Rear Block Kits to
achieve a slight rake to a level stance.
NOTE: 2010-2013 Tundra trucks with the 4.6 V8 engine will required (2044021) 1" rear block kit for a level stance.