Complete 22R and 22R-E long blocks, stroker short blocks, supercharger and turbo kits for the third-generation Celica — built in-house by LC Engineering since 1985.
Street Head Gasket
(Up To .060" Over)
LC Engineering carries a complete line of Head Gaskets for all types of applications. This is our most popular head gaskets for most 22 engines; it is a...
LCE Project 85' Garage Banner 30" x 48"
*Limited Edition
For years our customers have been asking us for banners for their garages, well, we finally were able to make that happen! Get yours,...
Resonator
(w/o Inlet & Outlet Tubes)
These are great to use as a muffler for that old school sound, or they can be used in conjunction with the LC Engineering Pro Flow Exhaust system to for a...
Resonator
(w/o Inlet & Outlet Tubes)
These are great to use as a muffler for that "old school" sound, or we have used them as a resonator to quiet down your existing exhaust system. The 18" length...
Flex Coupler
(2 1/2" x 6")
To reduce the stress on your exhaust system, we have these flex couplers to weld or clamp onto your pipe. Under acceleration, your engine has a tendency to torque to one...
Clutch Slave Cylinder
The clutch slave cylinder is typically located on the side of the transmission. The clutch slave cylinder receives hydraulic pressure from the clutch master cylinder which...
Steel Head Shim
(+.020")
For heads that have been milled beyond factory spec, we offer head gasket shims to bring the compression ratio back to where it should be. This will also prevent timing...
Weld On Flat Tab
(9/16" Hole)
Our weld on flat tabs are made from 1020 hot rolled steel, are 1/4" thick and are designed for a 9/16" bolt, they are 2" wide and 2 5/8" tall. The center of the hole...
Pro Header Gasket Set
Complete gasket set for the proper installation of our headers. Pro header gasket kits come with a two-bolt OE collector gasket to match the collector on our Pro Header.
Kit...
Pro Header Gasket Set
Complete gasket set for the proper installation of our headers. Pro header gasket kits come with a two-bolt OE collector gasket to match the collector on our Pro Header.
Kit...
The third-gen Celica ran the 22R from 1982 and the fuel-injected 22R-E from 1983. That is the engine LC Engineering was founded on, and it means our catalog for this car is as deep as it is for any Toyota truck — with the advantage that a Celica weighs several hundred pounds less than the Pickup the same engine came in.
Complete Long Blocks
We build these as finished, ready-to-install engines rather than parts you assemble. Everything is machined, assembled and checked in our own shop:
Be honest with yourself about the stage. A Stage 3 in a street Celica needs the carburetion or injection sorted to match, and a Stage 5 is not a pleasant road engine. Most owners are better served by Stage 2 with the rest of the car brought up to it.
Related: the 1978-1981 Celica catalog covers the carbureted 20R and 22R. Not sure which long block suits your car and your budget? Talk to us first — we would rather build you the right engine than the biggest one.