Complete 22R and 22R-E long blocks, stroker short blocks, supercharger and turbo kits for the third-generation Celica — built in-house by LC Engineering since 1985.
22RE Cold Start Injector Block Plate Kit
(22RE EFI Intake Manifold)
This kit is designed to allow you to safely block of the cold start injector and supply when you are upgrading your efi system to...
Fuel Pump Block Plate Kit
This block off plate blocks the hole on the front of the cylinder head where a manual fuel pump would mount. Perfect for if you are using an electric fuel pump on an engine...
Seal Saver
(Rear Main)
Do you have a pesky oil leak coming from the rear main seal? Don't just keep swapping out rear main seals. LC Engineering carries this seal saver that slides right over the...
Throttle Position Sensor Plug
(Sidedraft)
This plug is only to be used with sensor, see Part #:
1061090, and is for the individual fuel injection throttle body set up that we sell, see Part #:
Aluminized Heat Sheath
(.75" x 3')
This aluminized sleeving reflects heat from wiring and hoses. Heat Sheath is easily cut to length. For use on cars, street rods, and trucks.
This product should...
Water Block Plate
(Center Of Head)
If you are installing an Offenhauser intake (or if you are eliminating the heater core), there won't be room for the heater core outlet off the cylinder head...
Exhaust Gasket
OEM style gaskets offer the best possible seal for your stock manifold or header. All the LC Engineering headers are designed to use the factory gaskets. Traditional paper exhaust...
Water Block Plate
(Timing Cover Passenger Side)
This block plate goes on the passenger side of the timing cover. Perfect for eliminating the unnecessary water hoses going around your engine...
Water Block Plate
(Timing Cover Driver Side)
This block plate goes on the driver's side back of the timing cover which is for deleting the factory heater return line on most 22's.
Oxygen Sensor Adapter
(2-Bolt Style To Thread In Style)
This kit will adapt a thread in style O2 sensor (18mm) to the Toyota two-bolt style. Includes gasket plate to adapt and two studs and nuts...
Hi-Lift Jack Rubber Isolator
The Trail-Gear hi-lift jack rubber isolator is is the perfect fix for that hi-lift or hi-lift style jack you have rattling around in the back or your truck. The...
Teflon Heat Isolation Gasket
(Intake)
Teflon Heat Isolator kits keep the power-robbing heat away from the intake air. By keeping the heat out of the intake manifold, the incoming air is cooler,...
The third-gen Celica ran the 22R from 1982 and the fuel-injected 22R-E from 1983. That is the engine LC Engineering was founded on, and it means our catalog for this car is as deep as it is for any Toyota truck — with the advantage that a Celica weighs several hundred pounds less than the Pickup the same engine came in.
Complete Long Blocks
We build these as finished, ready-to-install engines rather than parts you assemble. Everything is machined, assembled and checked in our own shop:
Be honest with yourself about the stage. A Stage 3 in a street Celica needs the carburetion or injection sorted to match, and a Stage 5 is not a pleasant road engine. Most owners are better served by Stage 2 with the rest of the car brought up to it.
Related: the 1978-1981 Celica catalog covers the carbureted 20R and 22R. Not sure which long block suits your car and your budget? Talk to us first — we would rather build you the right engine than the biggest one.