Axles

Front CV Axle Shafts Keep Your Front End Turning Smoothly

Front CV axles wear out faster once you add a suspension lift, since the steeper angle puts extra strain on the joints. Our heavy duty CV axle is built for extended travel and holds up to the added stress that comes with lifted trucks and larger tires, making it the go-to upgrade for anyone running their Tacoma or 4Runner hard off-road.

For direct replacements, we carry both front axles for manual locking hubs and front axles for automatic locking hubs, so you can match the correct axle to your truck's hub system. Picking the right axle depends on which hub system your truck uses, so check that before you order. A worn CV axle often shows up as clicking noises during turns or grease flung inside the wheel well, both signs it is time for a replacement before the joint fails completely.

View Bearing Selection

Front Axle Housings For Big Tires and Lift Kits

Bigger tires and lift kits put more stress on your front axle housing than the factory design was ever meant to handle. Upgrading your CV axles alongside a stronger front housing helps correct pinion angle and axle width so your steering geometry stays accurate even after a lift. Trail riders who twist their trucks over rocks and ledges will notice the difference in strength right away.

Shop 1st Gen Tacoma Drivetrain Parts

Rear Axle Housings and Shafts That Add Strength

The rear axle takes a beating every time you put power down on loose dirt or climb a steep grade, and stock parts were not built for aggressive tires or added horsepower. Two products stand out for drivers who want to stop rear axle failure before it starts.

• Rock Assault Rear Axle Housing uses thicker DOM tubing and a full gusset weld for added strength under torque.
• Longfield 4340 Chromoly Rear Axle Shafts are forged to handle larger tires without twisting or snapping.

Pairing a stronger housing with chromoly shafts gives you a rear end that can handle bigger tires, locked differentials, and hard trail use without leaving you stranded.

Browse 1st Gen Tacoma Driveshafts

Hardware and Accessories For Your Toyota Tacoma 1st Gen Axle Setup

A complete axle job needs more than just the big parts. Small components keep everything sealed, connected, and easy to service down the road.

• Rear CV Driveshaft U Joint replaces the outside snap ring style joint found on certain rear driveshafts.
• Axle Inspection Plug Installation Kit adds a large fill and inspection cap so you can check your ring gear without pulling the cover.

These smaller parts finish the job and make future maintenance easier, so grab them while you are placing your axle order. If you are not sure which CV axle fits your truck, our team at LCE Performance is happy to help. We have served Toyota owners for decades and our catalog covers every generation from vintage trucks to the newest models, so reach out with any questions before you order.