Odds and Ends

Dana 60 (29-Spline) to Toyota Triple-Drill Conversion Flange The ultimate solution for Dana 60 axle swaps is here. The conversion flange is specifically designed for off-roaders who want to mate a heavy-duty Dana 60 or Rock Assault 9" axle to a reliable...

LCE Dual-Axle Differential Breather Relocation Kit Protect your drivetrain from water contamination and premature seal failure with the LCE Differential Breather Kit. In any 4WD vehicle, drivetrain assemblies like differentials, transmissions, and...

Rear CV Driveshaft U Joint (Outside Snap Ring Design) On various Toyota models you may find this constant velocity "CV" joint on its rear driveshafts. These are unique in the fact that they will use a snap ring but located on the outside as opposed to...

Differential Drop Spacer Kit Lifting a Tacoma, Tundra, Sequoia or 4Runner increases the angles on the CV joints and boots, which accelerates wear. These solid aircraft-grade 6061-T6 aluminum spacers and zinc-plated Grade 8 hardware move the front...

OEM Shifter Boot (Manual Transmission) It's common for the factory shift lever boot to degrade over time, crumble and disintegrate. This often results in dirt and mud getting into the transmission shifter then into the transmission. This simple rubber...

Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the ball end of the shift lever (transmission side). We...