OE Head Bolts If you ever remove your cylinder head, you should always replace the head bolts to prolong the service life of your engine. Cylinder head bolts go through a lot of stress, even in stock engines, and retorquing used bolts can sometimes...

Billet Valve Cover Hardware Kit 22R/RE (Includes Billet Valve Cover Seals, Studs & Acorn Nut) Looking to turn heads at your next show? Then look no further than our new hand polished fasteners that are guaranteed to catch peoples attention when looking...

Flywheel Bolt Kit (OEM) Connect that flywheel with confidence. These OEM flywheel bolts are just what the doctor ordered to connect your flywheel to your engine. They have a black oxide finish to help resist rust and corrosion. OEM Toyota Part #:...

Torsion bolt kit (4WD ONLY) (OEM) When you change or are adjusting the torsion bars it's a good idea to have new hardware. Years of use and extremely long threads on these bolts could get damaged and unusable. if you're changing the torsion bars on the...

Timing Cover Hardware (Dual Chain Applications) Timing Chain Bolt Kits for the early dual-row cover or the LC Engineering dual row conversion kit. All Hardware is zinc plated, or black oxide coated. This is the hardware used in the Timing Chain...

Timing Cover Hardware (Single Chain Kit) This kit is all the hardware you will need for the installation of the late model Timing Chain Cover in most applications. All hardware is zinc plated, or black oxide coated. NOTE: This kit will not address any...

OEM Flywheel Bolt Kit Connect that flywheel with confidence. These OEM flywheel bolts are just what the doctor ordered to connect your flywheel to your engine. They have a black oxide finish to help resist rust and corrosion. Recommended to be replaced...

OEM Bell Housing to Block Bolt Set After many years of sitting in your engine compartment, the bell housing bolts might not be in the best shape, especially if you've had the engine or trans out a few times. Instead of scrambling to replace a bolt or...

Valve Cover Hardware Kit Valve cover hardware kit includes (4) studs and (4) chrome acorn nuts, for the 20R/22R/RE (all years). We also use the studs in this kit for mounting 1" spacers to adapters, nuts are not used. This product should not be used...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 1.25 x 48mm long, heat-treated plated header mounting studs are stronger than stock. Works with a stock...

Front Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. It is recommended to use Anti-seize when installing...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...